Cosatto NITTY GRITTY Ooba Fox Tale Manual Del Usuario página 7

Harness
Bumper bar
Footmuff
Seat unit hood
Calf support
Seat unit raincover
Child car seat
adaptor
Car seat mode
26- Adjusting seat unit recline angle:
WARNING: Never adjust the seat unit with your child
in the seat.
27- Opening:
28- Closing:
29- Adjusting the strap length:
Slide the strap adjustor to suitable length (1, 2 & 3).
30- Adjusting the shoulder strap position:
31- Removing:
Unzip the rear of the backrest (1).
Push the shoulder strap retainer through the backrest (2).
Unfasten the fabric fastener at the bottom of the seat (3).
Push the waist strap retainer through the seat (4).
Push the crotch strap retainer through the seat (5).
Refitting is a reversal of this procedure.
32- Fitting:
33- Opening:
34- Removing:
35- Fitting:
Open the harness 27 and remove the chest pads & crotch pad (1).
Push the harness straps through the footmuff (2).
Attach the footmuff fabric fasteners to the rear of the backrest (3).
Refit the chest pads & crotch pad then close the harness 28 .
36- Preparation:
37- Adjusting:
38- Using the sun visor:
39- Using the viewing window flap:
40- Removing:
Refitting is a reversal of this procedure.
41- Adjusting:
42- Fitting:
Removing is a reversal of this procedure.
43- Using access zip:
44- Fitting:
Note: The child car seat adaptors are supplied with the "Ooba" TS.
The adaptors are handed.
45- Removing:
46- Note: The child car seat should only be fitted rearward facing.
47- Fitting:
48- Removing:
Press the memory release button (1). The button will stay depressed.
Press and hold the release button on the opposite side of the car seat (2).
Lift the child car seat off the chassis (3).