Genesis GMSDR1015LC Manual Del Operario página 6

Sierra ingleteadora compuesta deslizante de 254 mm
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Keep the motor air slots clean and free of chips
impair the flow of cooling air to the motor.
Make sure all the saw's adjustment handles are tight
is positioned in one of positive stops. Do not forget to tighten the rear mounted bevel adjustment handle.
Never apply lubricants
Never use saw blades
Never start the tool
Allow the motor to attain full speed
Always keep the blade guards in place
Never reach around
Never lock the switch
Never attempt to recut small pieces.
Never cut ferrous metals or masonry
like products.
• Do not perform free-hand cutting operations
and table. Use clamps to hold the work when possible.
• Long or wide workpieces should be properly supported.
IMPORTANT: After completing the cut
come to a complete stop before returning the saw to a raised position.
Turn off the saw and allow the blade to completely stop
area or removing debris and off-cuts in the path of the blade. Coasting blades are dangerous.
Turn off the saw and allow the blade to completely stop
securing the workpiece, changing the workpiece angle, or changing the angle of the blade.
Never perform layout,
is running.
Turn the machine "off" and disconnect the machine
installing or removing accessories, before adjusting or changing set-ups, or when making repairs.
Disconnect the machine
machine.
If any part of your miter saw is missing, damaged, or fails in any way,
electrical component fails to perform properly, shut off the switch and remove the plug from the power
source. Replace missing, damaged, or failed parts before resuming operation.
WARNING:
instructions before using this equipment. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious personal injury.
6
All manuals and user guides at all-guides.com
to the blade when it is running.
rated for operation at less than 5,000 rpm.
with the workpiece against the blade.
prior to starting the cut.
or behind the saw blade.
in the "ON" position.
. This miter saw is designed to cut wood and wood-
assembly or set-up work on the saw table or work area while the machine
from the power source and clean the work area before leaving the
Read and understand all warnings, cautions and operating
SAVE THESE INSTRUCTIONS
10" Sliding Compound Miter Saw
Operator's Manual
, dust, or other obstructions which may
before cutting, even if the table
and use at all times.
. Hold the work firmly against the fence
, release the power switch and allow the blade to
before cleaning the blade
before removing or un-
from the power source before
GMSDR1015LC
or any
Tabla de contenido
loading

Tabla de contenido