Genesis GMSDR1015LC Manual Del Operario página 10

TABLE EXTENSIONS (FIG 3)
Your saw comes with two table extensions (1). They can be installed
in either the left or the right side of the saw base.
To Install the Table Extensions
1. Loosen the extension lock knob (2).
2. Insert the ends of the table extension into the holes (3) in
the side of the base and adjust the extensions to the desired
length.
3. Secure the extensions by tightening the extension lock knob.
The extension comes with a stop block (4) installed on the farther
side of the extension. The stop block is useful as a stop for making
repetitive cuts to the same length.
To Use the Stop Block
1. Tilt the stop block up as shown on FIG 3.
2. Adjust the extension to desired cutting length.
3. Make a test cut in scrap material and measure the length of
the workpiece.
4. Make any necessary adjustments.
REAR SUPPORT FOOT (FIG 4)
A rear support foot (1) is provided to improve the stability of the
saw. Insert it to two holes on the back of the base. Tighten the
locking screw (2) located on the bottom of the base to secure it.
WORK CLAMP ASSEMBLY (FIG 5)
WARNING:
clamp assembly may interfere with the operation of
the blade guard assembly. Always make sure there
is no interference with the blade guard prior to beginning any cutting operation to reduce
the risk of serious personal injury.
This miter saw is equipped with a Hold down Work Clamp (1). The work clamp can be positioned in the provided
mounting holes in the base behind the miter fence to the right and left of the cutting head. Insert the clamp
column (3) into the mounting hole (2). Secure it by tightening the screw (6). Use the clamp lock screw (4) to
quickly secure the clamp in position. Use the clamp tightening screw (5) to secure workpiece against the miter
table as needed, especially small workpiece.
The work clamp provides greater control by clamping the workpiece to the fence or the saw table. It also
prevents the workpiece from creeping toward the saw blade. This is very helpful when cutting compound miters.
NOTE:
Depending on the cutting operation and the size of the workpiece, it may be necessary to use a
C-clamp instead of the hold down work clamp to secure the workpiece prior to making the cut.
CHANGING THE SAW BLADE (FIG 6, 7, 8, 9)
WARNING:
source before performing any work on the tool.
WARNING:
equal to or greater then the nameplate rated RPM of this miter saw.
WARNING:
WARNING:
contact the blade guards or produce poor quality cuts in the workpiece.
10
All manuals and user guides at all-guides.com
In some operations, the work
Be sure that the tool is switched off and unplugged from the power
Use only 10 inch diameter saw blades and are rated for speeds
Use only blades designed for cross-cutting operations.
Do not use thin kerf blades with deep gullets which may deflect and
10" Sliding Compound Miter Saw
Operator's Manual
FIG 3
1
3
4
FIG 4
1
FIG 5
4
6
GMSDR1015LC
2
2
5
1
3
2