Statement Of Use; Maintenance Instructions - Desoutter SSCM Manual De Instrucciones

Part no 6159935740
Issue no 01
Series no -
Date 09/2006
Page 6 / 50

STATEMENT OF USE

This control module must be used with controllers:
ESP1-1 / ESP1-2 / ESP2-1 / ESP2-2 and SLK
range screwdrivers. No other use permitted. For
professional use only.
DATA
(See page 4).
OPERATING INSTRUCTIONS
1 Switch off the power controller
2 Correctly connect the cable to controller and
screwdriver
3 Turn on the power controller and use the
potentiometers to adjust the slow-start speed
and slow-start time.
slow-start time
adjuster
4 Use the bypass switch to activate the slow-
start function when
deactivate this function when untightening
• To use signal contact output, open the case
and connect to the relay (Normally Open).
• Always use the correct CP cable / cord to
connect controller to the mains power
supply. Do not modify the cable / cord or use
it for other purposes.
• Use only genuine CP replacement parts.
• Do not drop SSCM or treat it roughly.
• The power controller is not protected against
splashing water
temporary.
slow-start speed
adjuster
tightening and
nor immersion, even

MAINTENANCE INSTRUCTIONS

•
Only experienced and qualified personnel
(authorized electricians) are entitled to open
and have access to the inside of the power
supply.
• If in doubt, return to a CP-authorized service
centre (contact your local CP Sales for details)
• Inspect the mains cable / cord for damage
daily.
• Replace if damaged.
• When dismantling and assembling, follow
normal engineering practices. Unsolder only
those wires
removal. Always note colour code and
location of wires for correct assembly. Refer to
the illustration and build components into sub-
assemblies. On assembly, ensure earth strap
is properly secured.
When disposing of components, lubricants,
etc ... ensure that the relevant safety
procedures are carried out.
© Copyright 2006, CP
All rights reserved. Any unauthorized use or
copying of the contents or part thereof is prohibited.
This applies in particular to trademarks, model
denominations, part numbers and drawings. Use
to
only authorized parts. Any damage or malfunction
caused by the use of unauthorised parts is not
covered by Warranty or Product Liability.
necessary for component