Voyager VOM74WP El Manual Del Propietario página 12

VOM74WP
General:
1. Choose the monitor and camera loca ons.
2. Install all required cables in vehicle. A 3/4"(19mm) hole should be drilled for
passing camera cables through vehicle walls, barriers, etc.
Install split grommets where applicable. If addi onal cable
install convoluted tubing over the cable.
3. cable/wiring has been routed and components are in place, temporarily
make all system conne ons and perform a system f
does not operate properly, see the
4. Make sure all cables are routed away from hot or moving parts and away from
sharp edges. Secure cables with wire es.
Backup (Rear) Camera
Rear-mounted cameras used for monitoring while backing up must be

connected to the CA1 input. Trigger#1 must be connected to the reverse gear
light circuit in the vehicle.
Side Camera
If side monitoring cameras are installed, they should be connected to either CA2

or CA3 inputs. Triggers 2 and 3 should be connected to the vehicle's turn signal
circuits.
Trouble
Blue Screen indicates No video signal. Check camera, cables, and all

connec ons.
ng
12
on is required,
check. If the system