Hydrofarm Phatom II PHB2010 Manual De Instrucciones página 3

2. Install the lamp firmly into the lamp socket
and connect the lamp cord to the ballast.
3. Plug the power cord into the power input
panel on the side of the ballast.
4. Plug the power cord into the power source
(electrical outlet).
5. Dimmable ballasts only: Press the dimmer
button to your preferred setting (60%, 75%,
100%, or Super).
USING THE BADR UNIVERSAL
RECEPTACLE SAFETY CLIP
The wire clip included in this hardware support
bag is designed for all BADR equipped ballasts
sold by Hydrofarm. This clip is to be used
to secure your lamp cord body connection
in place, protecting the fixture from being
unplugged when kicked or moved. It is a single
piece of metal wire with an open-ended prong
configuration (Figure 1).
Figure 1
ATTACHING THE CLIP
1. Remove the safety clip from its packaging.
2. Unplug the ballast power supply cord from
the wall or the timer.
3. Spread the two metal prongs apart so they
fit over the holes on either side of the BADR.
The holes are in the grooved portions of
either side of the fixture lamp cord head.
It may be helpful to slide the piece of black
plastic blocking the outlet not in use
(Figure 2).
Figure 2
INSTRUCTIONS
4. Press the metal prongs into the holes to
secure the clip (Figure 3).
5. Plug the reflector lamp cord into the proper
receptacle.
6. Swing the support clip towards the fixture
lamp cord body so it is aligned with the cord
(Figure 4).
Figure 4
7. Press the support clip over the lamp cord
head to secure the connection.
Plug the ballast back into its power supply.
MOUNTING THE BALLAST ON THE
WALL
• Using the template on page 4, mark the
mounting screw positions on the wall.
Screws need to be 145 mm apart to
ensure the screw head can be inserted into
the hole on the back of the ballast. It is
recommended that the screws be mounted
in a wall stud. If that is not possible, please
use drywall anchors rated for at least 15
pounds.
• Install the screws (not provided) into the
stud. Install to the proper depth of 15 mm.
• Slide the ballast onto the screws.
• We recommend that you mount the ballast
vertically, with the output connector
towards the bottom, for optimal cooling.
Figure 3
3