KALLISTA P29303 Guia De Instalacion página 7

3/4" Adapter or
Solder Direct
3/4"
Copper
or Pipe
3/4"
Elbow
48" (122 cm)
To Floor
3. Install the Valve – Single Showerhead Only
Install the valve on the support framing so the "UP" mark on the
valve is facing upward.
Connect the water supplies to the valve body using elbows, 3/4"
copper tubing or pipe, and adapters (if needed). Use thread
sealant on all threaded connections.
Secure the piping to the framing. This may reduce or eliminate
the possibility of water hammer when the user turns the trim
handle to the ON or OFF position.
Temporarily install a 1/2" nipple to the shower elbow so it
extends at least 2" (5.1 cm) beyond the finished wall.
Kallista
72"-78"
(182.9 - 198.1 cm)
To Floor (Typical)
Temporary
Nipple
Cold
Supply
Hot Supply
7 1081330-2-A