Troubleshooting; Scrapping - Nilfisk Advanced Terra 4300B Instrucciones De Uso

ENGLISH

TROUBLESHOOTING

Problem
The machine does not start when
turning the ignition key to "I".
The machine does not move
when pressing the pedal.
The main broom does not work.
The side brooms do not operate.
The machine collects little debris/
dust.
The filter shaker does not operate. The F2 fuse in the box is open.
The machine operates only when
stationary, otherwise the red
warning light turns on.
The battery autonomy is low.
The drive system electronic board
malfunction led is flashing.
For further information contact a Advance Dealer, where it is possible to consult the Service Manual.

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
law in force:
– Batteries
– Polyester dust filter
– Main and side brooms
– Plastic components
– Electrical and electronic components (*)
(*) Refer to the nearest Advance Center especially when scrapping electrical and electronic components.
24
INSTRUCTIONS FOR USE
Possible cause
The battery connector is disconnected.
The F1 fuse in the box is open.
The battery charger cable is connected to the electri-
cal mains.
The parking brake is engaged.
When starting the machine with the ignition key, the
pedal is pressed, or the operator is not yet on the
driver's seat.
The FT fuse is open.
The FA fuse is deactivated.
The main broom is not lowered.
The FB fuse is deactivated.
The vacuum system is turned off.
The F4 fuse in the box is open.
The dust filter is clogged.
The hopper is full.
The skirts are not properly adjusted or are worn.
The brooms are not properly adjusted.
The batteries are discharged.
The batteries are dead.
The battery capacity is low.
The drive system is malfunctioning.
Terra™ 4300B - 1464035000
Remedy
Connect the battery connector.
Replace the fuse.
Disconnect the battery charger cable from the electri-
cal mains.
Disengage the parking brake.
Start the machine with the ignition key, only after
being on the driver's seat and without pressing the
pedal.
Replace the fuse.
Reset the fuse by pressing the relevant switch.
Lower the main broom.
Reset the fuse by pressing the relevant switch.
Turn on the vacuum system with the switch.
Replace the fuse.
Clean the dust filter by using the filter shaker or by
disassembling it.
Empty the hopper.
Adjust/replace the skirts.
Adjust the broom height.
Replace the fuse.
Charge the batteries.
If the problem persists, replace the batteries.
Replace the batteries.
Buy batteries with higher capacity (see the Technical
Data paragraph).
To detect the failure, refer to the Service Manual (at
any Advance Dealer).
06/2009