Power Supply - GYS NOMAD POWER 20 Manual De Instrucciones

SMART
BOOSTER CABLE
Error
2
Start
3
4
30"
Start
5
Error
7
8
CHARGING MOBILE PHONES

POWER SUPPLY

NOMAD POWER 20
If the lights «Start» and «Error» flash alternately in green and red, the product is ready.
If the red light only is ON, the internal battery voltage of the NOMAD POWER is too low.
In this event, charge your device.
Make sure the NOMAD POWER is charged by checking the number of indicators on the
device (minimum of 3 indicators ON (see page 6)).
1- Connect the red clamp to the (+) of the battery.
2- Connect the black clamp to the (-) of the battery.
If the «Start» light is green and the «Error» light turns off, everything is ok.
The green light stays ON for 30 seconds so the user has 30 seconds to go and start his
vehicle.
(If no action is done during this time, the jumper cable turns itself off and the «Start»
and «Error» indicators will flash again alternately. Unplug and plug back your jumper
cable to the connector device (see step 1).
If only the «Error» indicator is turned ON, starting the vehicle is not possible (see page
8 for more information).
Starting the vehicle: The «Error» indicator flashes red and an alarm beep goes off.
Remove immediately the 2 clamps of the vehicle battery and unplug also the jumper
cable from of the connector.
1 - Connect the cable to the NOMAD POWER USB port 5V 4A
2 - Select the appropriate adaptor for your mobile phone or tablet and plug it
in. The NOMAD POWER starts the charge automatically.
1 - Plug the auxiliary cable to PC port 19V 3.5A
2 - Select the appropriate connection for your laptop and connect it on the
auxiliary cable.
3 - Plug the auxiliary cable with the right connection on the power supply
socket of your laptop.
4 - Press the ON button to start the charge.
EN
.
of the NOMAD POWER.
7