General Working Instructions; Application And Storage Of The Push Stick; Working Instructions For Surface Planers; Working Instructions For Thicknessers - Parkside PADM 1250 A1 Traducción Del Manual De Instrucciones Original

1. Set the planing table (23) to the lowest
position.
2. Perform the visual inspection.
General working
instructions
• Secure a long workpiece from tipping by
using a roller table or roller block. There
must be one support in front of the feed
table and one behind the discharge ta-
ble. The height of the support must be set
so that the workpiece rests horizontally
on the feed table and can be carried
horizontally from the discharge table.
• Do not machine splintering material or
material which may have hidden metal
parts. Splintering material can cause
injury to the user. Metal parts that come
into contact with the blade can cause
the workpiece to break apart, which
can also lead to injuries.
• Wood that has lots of knots and knot-
holes can also cause the workpiece to
break apart. Do not machine this wood.
• Do not stand directly in front of the
machine during operation and stand on
one side.
• If the blade shaft blocks during opera-
tion, switch off the machine and discon-
nect the mains plug.
Remove the workpiece and make sure
that the blade shaft can run freely again.
Application and storage of
the push stick
• Use the push stick when machining
small/short workpieces.
• Using the push stick, push the work-
piece over the feed table towards the
discharge table and blade shaft.
• When not in use you can hook the
push stick (18) into the holder (29) on
the back of the device housing (11). See
illustration
.
Working instructions for
surface planers
• When working, completely cover the
planer blade with the blade cover at the
points where you are not planing. Risk
of injury!
• Adjust the machine to the desired set-
ting. Turn on the machine. Place the
workpiece on the planing table. Push the
workpiece over the blade shaft using the
push stick if necessary.
Working instructions for
thicknessers
• Adjust the machine to the desired setting.
Turn on the machine. Place the workpiece
on the feed table. Push the workpiece
towards the blade shaft, using the push
stick if necessary, until the feed engages.
• When the feed engages, do not pull or
push the workpiece.
Just support the workpiece.

Switching on/off

Switching on: Press the On switch (9).
Switching off: Press the Off switch (10).

Overload protection

In the event of overload, the machine
switches off automatically to protect the mo-
tor (➞ overload protection).
If the machine switches off automatically,
wait briefl y and then press the overload
switch (8) (reset). You can then start the ma-
chine again using the On switch (9).
GB IE
29