DeWalt DCR017 Traducido De Las Instrucciones Originales página 31

Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm 2 ; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
Inserting a Battery Pack (fi g. 1, 3)
WARNING: Use only D
packs and chargers.
NOTE: Make sure your battery pack is fully charged.
If the battery pack does not produce sufficient
power, charge the battery pack following the
instructions in the manual of the charger.
NOTE: To ensure maximum performance and life of
Li-Ion batteries, charge the battery for a minimum of
10 hours before first use.
1. Release the latch (i) to open the battery
compartment cover.
2. Insert the battery pack (s) into the receptacle (j)
until it is fully seated.
3. Close and latch the battery compartment cover.
FUEL GAUGE BATTERY PACKS (FIG. 3)
Some D WALT battery packs include a fuel gauge
E
which consists of three green LED lights that
indicate the level of charge remaining in the battery
pack.
To actuate the fuel gauge, press and hold the fuel
gauge button (t). A combination of the three green
LED lights will illuminate designating the level of
charge left. When the level of charge in the battery
is below the usable limit, the fuel gauge will not
illuminate and the battery will need to be recharged.
NOTE: The fuel gauge is only an indication of the
charge left on the battery pack. It does not indicate
tool functionality and is subject to variation based
on product components, temperature and end-user
application.
To Install the Coin Cell Battery
(fi g. 1, 2)
Your radio is equipped with memory capacity in
order to store the time and your selected memory
channels. When the radio is OFF, this memory
capacity is powered by one coin cell battery that is
included with the radio.
1. Turn the charger/radio off and unplug from the
power source.
2. Open the battery compartment by lifting the
battery compartment latch (i).
3. Unscrew the screw (r) on the battery door (l).
4. Press down on the battery door latch and pull
to open.
WALT battery
E
5. Install the coin cell battery (m) according to the
diagram inside the coin cell battery area.
6. Replace the battery door, insert screw and
tighten.
7. Securely close the battery compartment.
NOTE: To reset the LCD display, clock and presets,
remove the coin cell battery and re-install it. Follow
this procedure if the screen seems to lock in place.
OPERATION
Instructions for Use
AC Operation (fi g. 4)
Unwrap power cord and plug into 110 or 230 V AC
wall outlet.
WARNING: When replacing battery,
replace it with the same brand and type.
Observe correct polarity (+ and –) when
replacing batteries. Do not store or
carry batteries so that metal objects can
contact exposed battery terminals.
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: Do not place the charger/
radio in locations where it may be
exposed to dripping or splashing.
EN GL IS H
29