Aqua Medic Qube control Manual De Instrucciones página 7

Fig. 2: Connections at the Aqua Medic Qube
1. Manual adjustment channel B
2. Manual adjustment channel W
3. Socket for control cable
4. Outlet for control cable (for controlling several Qubes)
5. Power supply
The Qube control and remote control are not waterproof. Therefore, don't install them in
wet, humid places. Furthermore, they have to be protected from
Insert the plug of the Qube's power supply to be controlled into the socket 3 of the Qube control
(Fig. 1). Then, connect it by the connecting cable of socket 2 to the socket of the power supply of
the Qube (see Fig. 2, No. 5).
The control cable has to be connected to socket 1 of the Qube control and in socket 3 of the Qube.
More Qubes can be connected via socket 4 (Fig. 2) by using an additional control cable. This has to
be plugged in socket 3 of the next Qube. The manual adjusting dials (Fig. 2, No. 1 and 2) are then
inoperative.
Programming the Qube control:
To set the time, press the button with the clock symbol on the remote control. The minutes start
flashing and can be adjusted by using the +/- keys. By pressing the button with the clock symbol
again, the hours can be adjusted. By using the SAVE button, the time will be saved.
By pressing the EXIT button, the menu can be left without making any alterations. By pressing
ON/OFF, the Qube can be switched on and of manually. By pressing RESET, all programs will be reset
to the original setting.
All settings are made in steps of 5%: 0 = 5%, 20 = 100%
1. Twilight phase
8:30 - 9:00 0 - 6 channel W
8:30 - 9:00 1 - 10 channel B
2. Sunrise
9:00 - 12:00 6 - 20 channel W
9:00 - 12:00 10 - 20 channel B
corrosion from salt water.
7