Homelite HCS3335A Manual De Utilización página 47

GB
F D E I P
REPLACING THE SPARK PLUG
See Figure 66.
This engine uses a Champion RCJ-6Y with .025 in.
electrode gap. Use an exact replacement and replace
every 50 hours or more frequently, if necessary.
Remove the spark plug lead, by carefully rotating
■
back and forth whilst gently pulling upwards
Loosen the spark plug by turning it counter clockwise
■
with a wrench.
Remove the spark plug.
■
Hand thread the new spark plug, turning it clockwise.
Tighten securely with wrench.
Note: Be careful not to cross-thread the spark plug.
Cross-threading will seriously damage the cylinder.
Re-attach the spark plug lead by pressing firmly onto
■
top of spark plug
INSPECTING/CLEANING THE SPARK ARRESTOR
SCREEN
See Figure 67.
The muffler is equipped with a spark arrestor screen.
A faulty spark arrestor screen can create a fire hazard.
Through normal use the screen can become dirty and
should be inspected weekly and cleaned as required.
Always keep the muffler and spark arrestor on the saw in
good condition.
WARNING
Muffler surfaces are very hot during and after
operation of the chainsaw. To avoid serious
personal injury, keep all body parts away from
the muffler.
Allow the muffler to cool.
■
Remove the deflector retaining screw.
■
Remove the deflector to access the spark arrestor
■
screen.
If dirty, clean the spark arrestor screen with a small
■
wire brush. Replace the screen if it is cracked or
otherwise deteriorated. To obtain a replacement spark
arrestor, contact your Homelite service centre.
INSPECTING AND CLEANING THE CHAIN BRAKE
See Figure 68.
Always keep the chain brake mechanism clean by
■
lightly brushing the linkage free from dirt
Always test the chain brake performance after
■
cleaning. Refer to Operating Chain Brake for
additional information.
WARNING:
Even with daily cleaning of the mechanism, the
dependability of a chain brake to perform under
field conditions cannot be certified.
HCS3435A-25lgs manual.indd Sec1:44 HCS3435A-25lgs manual.indd Sec1:44
NL S DK N FIN GR HU
English
STORING THE PRODUCT
■
■
When storing 1 month or longer:
■
■
■
■
■
MAINTENANCE SCHEDULE
Check:
Fuel mixture level. . . . . . . . . . . . . . . . . . . . . . .Before each use
Bar lubrication . . . . . . . . . . . . . . . . . . . . . . . . .Before each use
Chain tension. . . . . . . . . . . . . . . . . . . . . . . . . .Before each use
Chain sharpness . . . . . . . . . . . . . . . . . . . . . . .Before each use
For damaged parts . . . . . . . . . . . . . . . . . . . . .Before each use
For loose fasteners . . . . . . . . . . . . . . . . . . . . .Before each use
For loose parts. . . . . . . . . . . . . . . . . . . . . . . . .Before each use
Inspect and Clean:
Bar . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Before each use
Complete saw . . . . . . . . . . . . . . . . . . . . . . . . . . After each use
Air filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Every 5 hours*
Chain brake . . . . . . . . . . . . . . . . . . . . . . . . . . . . Every 5 hours*
Replace spark plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yearly
Replace fuel filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yearly
* Hours of Operation
44
CZ RU RO PL SLO HR TR EST LT
Clean all foreign material from the product. Store it in
a well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
Observe local regulations for the safe storage and
handling of petrol.
Drain all fuel from tank into a container approved for
petrol.
Run the engine until it stops. This will remove all
fuel-lubricant mix that could become stale and leave
varnish and gum in the fuel system.
Squeeze primer bulb several times to purge fuel from
carburettor.
Drain all bar and chain lubricant from tank into a
container approved for lubricant.
Always place the scabbard over the guide bar and
chain before transporting or storing the unit.
I
LV SK BG
12/19/08 3:08:59 PM 12/19/08 3:08:59 PM