HoMedics enviraScape Manual De Instrucciones página 3

ASSEMBLY AND INSTRUCTIONS FOR USE :
1. Unpack the product. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump speed is controlled by the dial located at the
front of the pump. The speed is indicated by a "min" and "max" (Fig 1). At its highest speed
level, the dial will cease to move any further. To decrease the pump speed, move the dial
counter-clockwise toward the "min"sign. Similarly, at its lowest speed, the dial will cease to
move any further.
3. Lead the cord through the cord slot on the bottom of the base.
This will ensure that the unit is balanced when placed on a flat surface. Attach the A/C
adaptor to the base power cord. DO NOT plug into outlet at this time (Fig. 2).
Figure 1 Figure 2
Stones
Base Power
Cord
Switch
4
Top Tier
LED Light
Water Supply
Connector
Connector
Outlet
Middle Tier
Cut-Out
Stones
LED Light Cord
PVC
Cut-Out
Tube
Pump
Platform
Watermark
Base
Edge
Base
Supporting
Poles
Adaptor
Figure 3
Cut-Out
PUMP
Drawing on Base
Base Edge
Figure 4
LED Light Socket
Top Tier
Water Supply Connector
Larger Hole
LED Light Middle
Connector Tier
Figure 5
Stones
Water
Watermark
Figure 7
Figure 6
Drip Loop
4. Place the platform on the
supporting poles of the base
(Fig. 2).
5. Insert the PVC tube located under
middle tier into the pump (Fig. 2).
6. Insert the LED light cord through
the small hole located under the
middle tier (Fig. 2).
7. Align the cut-out at the bottom
edge of middle tier with the edge
of base so it sits flat on the base
(Fig. 3).
Note: Pump position should be
corresponding to the drawing on
base.
8. Insert the LED light connector into
the LED light socket on the
bottom of top tier, and then insert
the water supply connector on the
bottom of top tier into the larger
hole of middle tier (Fig. 4).
9. Add clean water into middle tier
(Approx. 300mls), and then into
base (Approx. 1l 67mls). The
water level should be even with
the watermark. Next, arrange the
stones provided on top tier,
middle tier and the platform as
desired (Fig. 5).
10.Plug the cord into 230V mains
outlet. The fountain is controlled
by the switch located on the
power cord. If pump doesn't
operate, rotate in-line switch once
to turn "on" and once more to turn
"off".
NOTE: Ensure that the electrical
cord loops below the electrical
outlet to form a 'Drip Loop' (Fig.
6). This will prevent water from
running down the cord into the
electrical outlet.
11.As this product has two flowing
directions, unplug the power
source before changing fountain
position. To do so, turn top tier
counter clockwise 90 degrees.
When water has stopped flowing
from it, switch the fountain back
on (Fig. 7).
5