Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ELECTRONIC MONITOR
To give you greater control over your
exercise, this electronic unit provides
simultaneous
read-outs
distance, exercise time, calories burnt
and pulse rate.
If at any time during exercise you
press the START/STOP button then all
of the unit's functions will stop.
Pressing the START/STOP button
again will restart the machine.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
Important. Deposit all spent batteries
or
waste
packaging
containers, figure 2.
FITTING THE ELECTRONIC
MONITOR
ATTACHING
CABLE.
Take hold of the cable (53), which is
sticking up out of the main post , Fig.
3A, and plug it into the connector (53a)
at the back of the electronic unit (P),
as shown in figure 3A
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connectors
(54 & 55), sticking out of the main post
, and plug them into the connectors
(54a & 55a) located at the back of the
monitor (P), as shown in Fig. 3A.
ATTACHING THE MONITOR
Release screws (C), Fig 1, at the back
of the monitor.
Next, slide the front of the monitor onto
the plate on top of the main post (B) in
English
of
speed,
in
special
THE
FEEDBACK
the direction of the arrow, Fig. 3, push
the cables down into the main post
making sure not the pinch any of the
cables.
Replace
removed previously.
Once you have checked that the
monitor works correctly, go on to fit the
trim covers to the handlebar.
MONITOR FUNCTIONS
This monitor has six keys: PULSE /
RECOVERY; DOWN ; ENTER; UP;
START/STOP; USER.
The top of the display shows USER;
START/STOP; PROGRAM
number);
LEVEL
PULSE (pulse rate).
The centre display shows the values
that have been recorded on the left
and the programs and graphs for the
exercise on the right.
At the bottom of the display there are
six windows that show TIME; SPEED;
RPM: DISTANCE; CALORIES and
PULSE.
This monitor also has 1 manual
program, 6 pre-set exertion level
programs; 1 user defined program, 1
Steady Watt Rate program
Heart Rate Control programs.
You can reset of all the values back to
zero by holding the START/STOP key
down for 3 seconds.
1.MANUAL PROGRAM
Press
the
switch the monitor on, the words
MANUAL 1 will appear on the screen.
Use the UP/DOWN keys to increase
or decrease the exertion level, there
10
the
screws
(program
(exertion
START/STOP
(C)
level);
and 3
key
to
Tabla de contenido
