Velleman CAMTVI8 Manual Del Usuario página 5

4. Guide the power and video cable [11] through one of the cable
slots [10] and fix the mounting plate [1] on the ceiling or wall
with the four screws.
5. Position the positioning ring [3] over the lens enclosure [5] onto
the mounting plate [1] and then fix the ensemble by screwing
the fixation ring [2] onto the mounting plate [1]. Make sure the
fixation ring is not screwed too tight to leave the option open to
position the lens into the direction of the desired field of
operation.
6. Connect the two wires for an analogue PAL signal; leave them
unconnected for a HD 1080P TVI signal.
7. Connect the video connector [A] to a monitor (not incl.) or a
sequential switcher/quad splitter (not incl.) in case of multiple
domes.
8. Connect the power connector [B] to a 12 VDC power supply (not
incl.).
9. Set up the desired field of observation by adjusting the position of
the lens enclosure [5] in the positioning ring [3].
10. Manually adjust the zoom [4] and focus [8] with their screws.
The location of the screws can be determined by looking at the
position of the light sensor [9].
11. Tighten the fixation ring [2] to secure the camera's position.
7. Technical Specifications
IP rating
pick-up element
number of pixels
resolution
DSP
min. illumination
IR LEDs
IR cut filter
max. IR projection distance 30 m
S/N ratio
lens
lens angle
WDR
AGC
V. 02 – 10/02/2016
CAMTVI8/CAMTVI8W
IP66
1/2.9" Sony Exmor CMOS image sensor
1920 (H) x 1080 (V)
1080p video
FH Techpoint (TP2801) & Fullhan chip
(FH8531)8520
0.001 lux
36
yes
> 50 dB (AGC off)
f2.8 - 12 mm
104° - 33°
yes
yes
5 ©Velleman nv