Sanus Systems VMCC1 Instrucciones De Montaje Internacional página 5

Step 3: Add Bar Brackets
Slide the lower Cross Tube through the Bar Bracket (e), the Axis Assembly, a second Bar Bracket and through the second Monitor Brack-
et. Tighten all three Vise Assemblies secure the Cross Tube once it is slid through the second Monitor Bracket. See Diagram 3 below.
cross tube
Step 4: Add Support bar
Slide the Support Bar (g) through the Bar Bracket (e), Axis Bracket (d) and through the other Bar Bracket. Make sure the Support Bar
is centered on the wall mount. Thread each 1/4 - 20 x 5/8 Bolt (k) through each hole in the bottom of the Axis Bracket until they bottom
out in the Support bar. See Diagram 4 below.
e
VMCC1ins_010606_ML.indd 5
monitor
bracket
Diagram 4
e
Diagram 3
e
axis assembly
e
g
monitor bracket
Detailed View
d
k
1/16/06 10:31:55 AM