THERMEx DAX Instrucciones De Montaje página 48

48 THERMEX DAx
INSTALLATION USING KEYHOLE BRAcKETS
The two keyhole brackets on the back of the hood can be used for hanging the hood. The installation can be carried out in the following way:
1
Measure out and mark the position of the
two keyholes.
4
NOTE: The screws must not be screwed in
further than the hood can be installed.
7
Tighten the screws so that the hood is se-
curely attached to the wall.
2
x2
Drill the holes into the wall using a suitable
drill for the type of wall.
5
Hang the hood on the screws.
8
Replace the filters in the hood and close the
glass cover.
3
x2
Ensure that the rawlplugs and screws are
suitable for the wall material in question and
insert them into the pre-drilled holes.
6
Open the glass door and remove the filter.
9
Install the exhaust outlet on the hood.
NOTE: This only applies when venting into
open air.
M 540235068209082018
x2
x2