Note; Tilting The Monitor; Joining The Monitor; Lowering The Height - Sony BKM-37H Manual De Instrucciones

Plug the female
connector into the
control unit.
10
Plug the connecting cable into the DC 5V OUT and
LAN (10/100) connectors at the side of the monitor.

Note

Be sure to plug the male connector of the cable into the
DC 5V OUT connector on the monitor.
Plug the male
connector into the
DC 5V OUT on the
monitor.

Tilting the monitor

Loosen the tilting screw located inside the cover of the
right stand and that of the left stand, and then tilt the
monitor by holding the top of the monitor and the bottom
of the monitor or control unit. Be sure to secure the tilting
screws after tilting.
Tilting screw

Joining the Monitor

Even when the control unit is not joined to the monitor, the
attachment stand can be attached to the monitor alone.
For assembly, see the following steps of - "Joining the
Monitor and the Control Unit".
BVM-L/PVM-L series monitors (page 18): steps 4, 5,
6, 8, and 9
Other monitors (page 21): steps 2 to 8

Lowering the Height

The installation height of the attachment stand can be
lowered when you remove the tilt units pre-installed on the
right stand and the left stand. Remove the tilt units before
the control unit is joined to the monitor.
Note
After the tilt units are removed, the monitor cannot tilt.
DC 5V OUT
connector
1
Loosen the tilting screws on the right stand and left
stand.
LAN (10/100)
connector
2
Remove seven screws from each of the right stand and
left stand.
Tilting screw
Tilt unit
Assembly
23