Ford Mercury Manual Del Usuario página 584

Locks and Security
3. Turn the key from the 1 (off)
3
position to 3 (on).
4. Cycle eight times rapidly (within
2
10 seconds) between the 1 (off)
4
position and 3 (on). Note: The
eighth turn must end in the 3 (on)
position.
5. The doors will lock, then unlock,
1
to confirm that the programming
mode has been activated.
6. Within 20 seconds press any button on the remote entry transmitter.
Note: If more than 20 seconds have passed you will need to start the
procedure over again.
7. The doors will lock, then unlock, to confirm that this remote entry
transmitter has been programmed.
8. Repeat Step 6 to program each additional remote entry transmitter.
9. Turn the ignition to the 1 (off) position after you have finished
programming all of the remote entry transmitters.
10. The doors will lock, then unlock, to confirm that the programming
mode has been exited.
Illuminated entry
The interior lamps illuminate when the remote entry system is used to
unlock the door(s) or sound the personal alarm.
The illuminated entry system will turn off the interior lights if:
• the ignition is turned to the accessory or on position, or
• the remote transmitter lock control is pressed, or
• after 25 seconds of illumination.
The dome lamp control (if equipped) must not be set to the off position
for the illuminated entry system to operate.
The inside lights will not turn off if:
• they have been turned on with the dimmer control, or
• any door is open.
The battery saver will shut off the interior lamps 10 minutes after the
ignition has been turned to the off position.
151
2010 Mountaineer (mnt)
Owners Guide (own2002), 1st Printing
USA (fus)