Ford Mercury Manual Del Usuario página 561

Driver Controls
Gate Operator & Canadian Programming
Console mount
Visor mount
During programming, your hand-held transmitter may automatically stop
transmitting — not allowing enough time for HomeLink to accept the
signal from the hand-held transmitter.
After completing Step 1 outlined in the Programming section, replace
Step 2 with the following:
Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the "cycling" process to prevent
overheating.
• Continue to press and hold the HomeLink button (note Step 2 in the
Programming section) while you press and release — every two
seconds ("cycle") your hand-held transmitter until the frequency
signal has been accepted by the HomeLink . The indicator light will
flash slowly and then rapidly after HomeLink accepts the radio
frequency signal.
• Proceed with Step 3 in the Programming section.
128
2010 Mountaineer (mnt)
Owners Guide (own2002), 1st Printing
USA (fus)