Delivery Scope - Brita PURITY 450 Quell ST Manual De Instrucciones

4 Installation
Caution: Prior to installation, read the Technical Data (Chapter 12) and the Operating and Safety
!
Information (Chapter 3). After the product has been stored and transported at temperatures below
0°C, it must be stored with the original packaging open for at least 24 hours before commissioning.

4.1 Delivery Scope

For installation of a PURITY Quell ST new fi lter, you need the packaging units pressure vessel
(incl. fi lter cartridge) and pressure vessel lid
Prior to installation, remove the entire delivery scope from the packaging and check that everything
is present:
1 x Pressure Vessel
1
1 x Pressure Vessel Lid
1 x Filter Cartridge
2
1 x Manual
1 x Carbonate Hardness Test
If part(s) of the delivery scope are missing, please contact your local BRITA Offi ce.
4.2 Assembling the Pressure Vessel and the Pressure Vessel Lid
•
•
•
•
•
•
4.3 Assembly of Inlet and Outlet Hoses
Note: The inlet and outlet hoses are not included in the standard scope of delivery. The use of
BRITA hose sets is recommended (Chapter 13).
• Fit inlet hose at the inlet of the connector head
6
nector head .
4
Note: Inlet "IN" and outlet "OUT" of the connector head
seals, therefore no additional fl at seals may be used here. Check that the O-rings are seated
correctly.
Caution: The max. tightening torque at the 1" and 3/4" connections must not exceed 15 Nm!
!
Only hose connections with fl at seals may be used. Hoses with conical screwed connections
damage the fi lter head connections and invalidate any guarantee claims. Only hoses that comply
with DVGW-W 543 may be used to connect the device.
Before assembly, note the direction of fl ow on the upper side of the fi lter head, "IN" = water inlet,
"OUT" = water outlet. Prior to installation, note installation dimensions and operating position
(Chapter 12). If no original hoses are used, the 1"–3/4"
the return valve is sealed correctly (pre-fi tted in the water inlet).
24
3
3
Stand with both feet on the kick loops
Lift the pressure vessel
are over the kick loops
Remove the transport protective cap
Check that the O-ring seal of the fi lter cartridge
groove and also check for dirt and damage.
Note: lubricant at the factory.
Stand on the kick loops
on the pressure vessel
handle must match the "INSERT" groove.
20
Press the pressure vessel lid
engages.
.
.
12
and turn it clockwise until the mantle handles
1
.
12
from the fi lter cartridge.
18
with both feet and place the pressure vessel lid
12
. The position of the arrow marking on the lid
1
down and turn clockwise until the lock
3
and outlet hose
4
are equipped with O-rings as
4
adapter supplied must be used to ensure
17
is correctly seated in the
2
at the outlet of the con-
10
1
16
3
15