Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1.
Carefully remove the heater from the bag and the gift box.
2. The heater must be placed on a flat level surface.
3. Plug the cord set into a electrical outlet. Be sure plug fits tightly in outlet. A loose fit
will cause overheating and damage the plug. Plug and cord set may feel warm
during normal usage.
4. When heater is plugged in and turn on the power switch on the rear of the unit, there
will be a "beep" and a red power light to indicate that there is power to the unit. The
red light will remain lit until the power switch is closed or the heater is unplugged
from the outlet.
5. Press the
POWER&MODE BUTTON will start the
6. Upon turning the heater on, the unit will be in the
FAN start to run, the "
in the LCD will be highlighted. The decoration light will be lit
one by one, then cycle.
7. When
POWER&MODE button is
"HIGH "heat mode(2000 watts), and the "H" in the LCD will be highlighted. The
decoration light will be lit from 1 on the left to 12 one by one, then cycle.
8. Pressing the POWER&MODE button once more will set the heater into AUTO mode
(2000 watts). Notice that the display now displays a SET TEMP indicator (see
THERMOSTAT
lighted.
9. Press the
POWER&MODE button again and the heater will be in the
watts). The
"F" in the LCD will be highlighted.
without any heat output.
10. Pressing the
POWER&MODE button again and the heater will go back to LOW heat
mode. Continuing to press the
LOW, HIGH, AUTO, FAN mode.
11. Press
OSC. button, the heater will oscillate left and right.
llation will stop.
12. To disconnect heater, press
off the power switch, then remove plug from outlet.
Timer Function.
hour of time. Press it again and the light indicates 2 hours. Press it a third time and
it indicates 3 hours. The total time that can be indicated at one time is 8 hours.
Continuing to press the
lights are off. When the time indicator lights are off, the heater will run continuously.
Once the timer has been set, the timer will count down the hours in 1 hour incre-
ments, and the LCD will display the remaining operating time, until the heater will
turn itself off.
Thermostat instruction
1.
Pressing the
POWER&MODE button until the display shows AUTO mode.
2.
To adjust set temperature, Rotate the
temperature and down to decrease the desired temperature.
3.
When the air temperature raises 2 degrees above the set temperature, the heater
will stop heating at once and stop blowing after 15 seconds.
4.
When the air temperature drops 2 degrees below the set temperature, the unit will
come back on.
" in the LCD will be highlighted . At the same time the "L"
pressed at this point, the heater will be set into
INSTRUCTION) . At the same time the "A" in the LCD will be
POWER&MODE button will cycle the unit
POWER&MODE button for above 3 seconds, and
Press the
Timer button once and the light comes on indicating 1
Timer button will cycle
heater.
LOW heat mode(1000 watts), the
FAN
mode is for fan-only operation,
through the settings until all timer
Thermostat knob up to
–15–
from 1 on the left to 6
FAN
mode(25
through
Press it again and the osci-
increase the desired
high-
turn
E
N
G
L
I
S
H
Tabla de contenido
