Torque Preselection - Flex ALi 10,8 Instrucciones De Funcionamiento

– To close the chuck, rotate it clockwise.
n Insert tools.
n Close the chuck fully.
n Carry out a test run to check that the tool
is clamped in the centre.
Tool holder (ALi 10.8 S)
Note
¼" screwdriver bits and ¼" bit holders
are held securely in the chuck.
n Insert tool into the tool holder.
n Pull tool lock forwards and press in the
tool all the way.
n Release tool lock.
n To remove the tool, pull tool lock
backwards.

Torque preselection

ALi 10.8:
18
ALi 10.8/ALi 10.8 G/ALi 10.8 S
ALi 10.8 G:
n Set torque preselection to the required
setting (ALi 10,.8/ALi 10.8 G):
– 1 – 11 : Screw position (ALi 10.8)
or
– 1 – 20 : Screw position (ALi 10.8 G)
– : Drill position
Notes
– The friction clutch is deactivated in the
drill position .
– At the correct setting the tool stops as
soon as the screw has been screwed in
flush.
Speed preselection
ALi 10.8 G:
n Set selector switch to the required setting
(H = quick/L = slow).