Read This First; Setting Up The Speaker Systems; Connecting The Audio Components - Denon AVR-1404 Instrucciones De Operación

6

READ THIS FIRST

This A / V surround Receiver must be setup before use. Following these steps.
Step 1
(page 5 to 8)
Choose the location to setup the speakers and connecting the components.
Step 2
(page 9)
Next, insert the batteries into the remote control unit.
Step 3
(page 9 to 12)
Finally, setting up the system.
7

SETTING UP THE SPEAKER SYSTEMS

2 Speaker system layout
Basic system layout
• The following is an example of the basic layout for a system consisting of six speaker systems and a
television monitor:
Subwoofer
Front speaker systems
Set these at the sides of the TV or
screen with their front surfaces as flush
with the front of the screen as possible.
Center speaker system
Surround speaker systems
8 CONNECTIONS
• Do not plug in the AC cord until all connections
have been completed.
• Be sure to connect the left and right channels
properly (left with left, right with right).
• Insert the plugs securely. Incomplete connections
will result in the generation of noise.
• Use the AC OUTLET for audio equipment only.
Do not use them for hair driers, etc.

Connecting the audio components (1)

CD recorder or Tape deck
OUTPUT INTPUT Connecting a tape deck
R L R L
Connections for recording:
R L R L Connect the tape deck's recording input jacks (LINE IN or REC) to this unit's tape
recording (CDR/TAPE OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck's playback output jacks (LINE OUT or PB) to this unit's tape
playback (CDR/TAPE IN) jacks using pin plug cords.
L
R L
R
R L
R L
Subwoofer jack
Connect the internal amplifier's subwoofer to the subwoofer
terminal. (Refer to page 8.)
AC OUTLET
Decoder with 6-channel analog • SWITCHED (total capacity – 100 W)
output The power to this outlet is turned on and off in conjunction with the POWER
operation switch on the main unit, and when the power is switched
between on and standby from the remote control unit.
No power is supplied from this outlet when this unit's power is at standby.
Never connect equipment whose total capacity is above 100 W.
NOTE:
Only use the AC OUTLET for audio equipment. Never use them for hair
driers, TVs or other electrical appliances.
ENGLISH
• Note that binding pin plug cords together with
power cords or placing them near a power
transformer will result in generating hum or other
noise.
• Noise or humming may be generated if a
connected audio equipment is used independently
without turning the power of this unit on. If this
happens, turn on the power of the this unit .
Power supply cord
AC 230V, 50Hz
AC OUTLET
AC 230V 50Hz
SWITCHED
100W MAX.
Connecting the AC OUTLET
5