Display Messages - Teac MD-5 Manual Del Usuario

... Track combination may not be possible.
Tracks created by other editing
operations sometimes cannot be
combined.
... Audio is interrupted during search.
When a track created by an editing
operation is searched, audio is
sometimes interrupted.
... Track numbers are not assigned
correctly.
When a CD is recorded through a digital
connection, short tracks may be
recorded depending on the contents of
the CD. Also, when auto track marking is
performed, the track numbers may not
be assigned correctly in some cases.
... The "TOC Reading" display will not
disappear.
"TOC Reading" is displayed for a longer
time than usual when a brand-new
recordable MD is inserted.
... Note the following when you attempt to
perform recording while erasing
(overwriting) the previous recording:
≠ The remaining recording time of the
MD may not be displayed correctly.
≠ After repeated overwrite operations,
it may no longer be possible to
overwrite recording. In this case, first
edit the previous recording (by
erasing tracks, etc.) then proceed to
the overwrite operation.
≠ The remaining recording time is
shorter after recording than it was
before recording.
≠ The overwrite operation is not
recommended if the track to be
overwritten contains noise. Since
recording is performed on a 6-cluster
basis (approx. 12
overwriting a noisy track may erase a
part of the track.
... It is not possible to assign a track title
during overwrite recording.
... Sometimes the maximum recording
time (60 or 74 minutes) will not be
available even after performing "ERASE
DISC".
In this case, try performing "ERASE
DISC" again. However, you will not be
able to UNDO it afterwards.

Display Messages

The following messages are displayed depending on the operation conditions.
Message
Blank Disc
Cannot Copy !
Cannot EDIT !
Disc Error !
Disc Full !!
D-IN UNLOCK !
ERASE DISC ?
ERASE TRK ?
Name Full !!
NO DISC !!
No Track !!
PGM Empty !!
PGM Full !!
Play Mode !!
Protected !!
Rec Error !!
Track Full !!
UNDO ?
UTOC Writing
seconds),
The recordable MD contains no recorded data.
Copying is not possible.
Editing is not possible.
The data in the MD is abnormal.
No more recording is possible.
Digital input connection is not made.
Is it OK to erase the recorded data on the MD ?
Is it OK to erase this track ?
The title memory is full.
No MD is inserted.
No track has been recorded.
Tracks have not been programmed.
No more tracks can be programmed.
The selected play mode is inappropriate.
The MD is protected against accidental erasure.
A playback-only MD is loaded.
A recording error occurred.
The MD has used up all its track numbers.
Is it OK to cancel the last operation ?
The recorded data is being written on the MD.
– 20 –
Description