Cressi DIGI 2 Manual De Instrucciones página 33

5. Change the CR2450 battery, taking care to position the new one
the same way, with the positive pole facing outward without
reclosing the cap.
6. Check that the display turns on, and wait for the countdown to
begin with the battery compartment still open.
7. Within one minute of the countdown beginning, reclose the
battery compartment closure cap.
When the operation is complete, the DIGI 2 console will run the
instrument seal test, which lasts a few minutes.
P80-DIGI 2.indb 33
When the test concludes, the DIGI 2 console will provide a response
regarding the battery change that was just performed:
8. PASS. The test was positive; the battery change was effective.
9. FAIL. The test was negative; the battery change must be
repeated because the instrument is not safe from flooding.
REPEAT THE STEPS TO CHANGE THE BATTERY
EN
33
13/06/19 14:01