Dive Screen - Cressi DIGI 2 Manual De Instrucciones

EN
28

DIVE SCREEN

If the DIGI 2 console is active, the dive will begin once a depth of 1.2
meters is exceeded.
 WARNING!
Do not dive with the smart cover inserted into the
display housing! Removing it at depth would cause the instrument
to turn on belatedly, resulting in incorrect measurements of the
parameters for depth, maximum depth, range, and dive time! Pay
the utmost attention!
 WARNING!
Do not dive if the DIGI 2 console display shows
any unexpected values, and contact a Cressi support center.
 WARNING!
Never bring the smart cover on the dive or get it wet.
Once a depth of 1.2 m is exceeded, the DIGI 2 console will show the
following data:
1. Current cylinder pressure (set in BAR or PSI); the number will
flash when the pressure falls below 50 BAR
2. Current depth (set in m or ft)
3. Maximum depth (set in m or ft)
4. Dive time (minutes) of the previous dive - temperature (set in c°
or f°). This information appears in rotation on the screen
5. Range (minutes): indicates time remaining until the threshold of
50 BAR is reached, calculated from the current depth and based
on average air consumption detected in the preceding minutes.
Battery status (see BATTERY chapter).
P80-DIGI 2.indb 28
 WARNING!
The dive is considered concluded after two
minutes on the surface (depth of less than 0.8 m). If you should
descend again during this period of time, the DIGI 2 console will
continue to increase the time (dive time preceding the second
descent), considering it a single dive.
 WARNING!
Cressi Sub S.p.A. strongly recommends ending
the dive with air reserves of at least 50 BAR. This amount of air is
provided only for any unplanned emergencies. Below 50 BAR, the
value indicated will flash.
1 second
5 seconds
13/06/19 14:01