NUK BP7 Instrucciones De Operación página 37

Using two breast shields:
5. Position both breast shields 10 with the
fitted silicone cushions 11 on your breast
so that your nipple is in the centre of the
shield. Gently press the breast shields in
place using the lower arm and hand to
ensure that there is a good seal when
expressing. In doing so, keep the
breast milk containers attached to the
breast shields
possible.
6. To start pumping, touch any of the
buttons 23,
Pumping will start with the fastest suction
rhythm and the lowest suction strength
(default setting).
7. Alternatively, you can also start the pump
first and select a pump setting which you
have found comfortable for single-sided
expressing (see
page 33). You then have both hands free
to put on the breast shields.
Caution! To ensure smooth pumping, never
allow the milk level to rise beyond the lower
rim of the lip valve 12.
Setting the suction strength
8. Use the buttons
and 25 to adjust the
suction strength to one of
4 levels.
Touch-and-hold will cause
the suction strength to adjust step by
step up to the maximum or minimum
level respectively.
The selected
displayed with 32 (First Choice
(Nature Sense).
You can adjust the suction strength any
time during the pumping session.
Setting the suction rhythm
9. Touch the
the suction rhythm to the next level.
Touch-and-hold will cause the suction
rhythm to adjust step by step until you
release the button.
13 as upright
24 or 25.
" Memory function"
24
suction strength
+
23 button once to adjust
The selected suction rhythm is displayed
with 28 (First Choice
Sense).
You can adjust the suction rhythm any
time during the pumping session.
Pause mode
10.Touch the Pause button
the pump unit into pause mode. To
as
continue pumping, touch the Pause
button
Memory function
The memory function can be used to save
the sequence of a pumping session from the
moment it is started.
11.To save a pumping session, you must
first change to pause mode by touching
the Pause button
12.Then touch the Memory
on
button
seconds.
While the session is being
saved, the symbol 29 (First
Choice
Once the session has been saved, the
pump will return to start-up mode.
13. To start the saved session, touch the
Memory button
is in start-up mode after being switched on.
7
The symbol 29 (First Choice
Sense) is lit.
Nature Sense model: in addition, the
screen background will change to red.
14. You can pause and resume the pumping
is
session at any time by touching the Pause
) or 39
button
session.
15. To exit the Memory function and return to
the default settings for the remainder of the
pumping session, touch either of the
buttons
the pump unit is in pause mode.
This will return your pumping session to
the default settings.
33
+
) or 33 (Nature
26 again.
26.
22 for at least 2
+
) or 34 (Nature Sense) will flash.
22 while the pump unit
26, even while running a saved
23, 24, or
26 to place
2 sec.
8
+
) or 34 (Nature
25 while