Regalo 1185 Manual De Instrucciones página 3

Assembling and Installing Your Gate
STEP 1
FRAME
ASSEMBLY SCREWS
Take the left and right gate frame halves (B)
and align the holes in the lower horizontal
tube. Place the frame halves together and
then using the frame assembly screws (G),
tighten the two halves together.
STEP 4
Repeat Step 3 with the top of the door frame.
STEP 2
HINGE TUBE
Take the hinge tube (H) and insert into the hole on
the top of the door. Slide down until hinge tube
goes all the way through the bottom of the door and
1 inch of the tube is exposed on the top and bottom
of the door.
STEP 5
Insert binding post (I) through the backside and hold
in place. Thread screw through the front side with a
screwdriver and tighten until secured.
STEP 3
With the door frame (B) laying on a flat surface,
slide exposed bottom of the door hinge tube
into the hole on the bottom of the door frame.
STEP 6
SCREW
BINDING
POST
Locate the (4) threaded spindle rods (F). Rotate
the adjustment wheels along the threading,
eliminating the gap between the adjustment
wheel and the rubber foot.
NOTE:
You will notice a slight gap between
the gate door latch and the frame. This is not
a defect. Your gate is a pressure mounted
gate and this gap will disappear once you
tighten your gate in its opening.
ADJUSTMENT WHEEL
RUBBER FOOT