Cleaning Tools - Hoover TurboPOWER WindTunnel U5415-900 Manual Del Usuario

Cleaning tools

Tools allow for cleaning surfaces
above the floor and for reaching
hard to clean areas.
The cleaner is ready for tool use
when handle is in upright posi-
tion.
CAUTION: Agitator continues to
rotate while cleaner handle is in
upright position. Avoid tipping
cleaner or setting it on furniture,
fringed area rugs or carpeted
stairs during tool use.
How to clean tools
To clean the hose, wipe off dirt with
a cloth dampened in a mild deter-
gent. Rinse with a damp cloth.
Cleaning tools may be washed in
warm water with a detergent. Rinse
and air dry before using.
2-16
E
G
H
Select proper tool
E. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian
blinds, baseboards, shutters, and
registers.
F. Furniture nozzle may be used
for upholstered furniture, draperies,
mattresses, clothing, automobile
interiors, and carpeted stairs.
G. Crevice wand may be used in
tight spaces, corners and along
edges in such places as dresser
drawers, upholstered furniture,
stairs and baseboards. It can also
be used for extra reach with the
dusting brush and/or extension
wand.
H. Extension wands are used to
give extra length to your hose. Use
them with any of the above tools.
2-13
Removing hose
When using cleaning tools, cleaner
handle should be in the upright
position. Also, turn cleaner OFF
before disconnecting and con-
necting hose to hose tube (A).
To use hose, lift hose end as shown.
Lower cover (B) onto hose tube.
When you are finished cleaning with
the tools, be sure to lift cover from
hose tube and reposition hose
end into tube.
2-17
F
I
Attach wand and tools
Attach tool, wand or crevice wand to
the hose (I) by pushing it firmly into
the hose. Attach second wand, tool
or crevice wand to the wand in the
same manner.
Twist wand or tool slightly to tighten
or loosen the connection.
The dusting brush (J) can be
attached to the crevice wand.
B
A
J
2-14
2-15
D
C
Extra reach hose
(available at additional cost)
Follow the steps below for attaching
and detaching the hose.
Push ON/OFF switch to OFF posi-
tion. Remove regular hose from
cleaner. Align end of extra reach
hose with projections (C) over slots
(D) in dirt duct (Fig. 2-14).
Slide hose into (D) and twist hose to
lock it into place (Fig. 2-15).
To detach hose, reverse procedure.
Attach wands or tools to the other
end of hose.
2-18
K
Check bag indicator
The indicator (K) will begin to show
red as the filter bag fills with dirt.
There are three conditions that will
cause the indicator to become com-
pletely red:
1. If the bag is full; change the bag.
2. If very fine materials have been
picked up, clogging the bag pores;
change the bag.
3. If there is a blockage in the nozzle,
hose, tools or at the bag opening;
remove the blockage (see "Clearing
blockages" section).
Continued
D
7