Stiebel Eltron Mini 2-1 Funcionamiento E Instalación página 15

INSTALLATION INSTRUCTIONS
7.3.1 Wiring
For 120 V units, the brown wire of the pigtail should be hooked up
to L (Load/Live), the blue wire to N (Neutral), and the green/yellow
wire to the ground GND.
For 208/240 V units, the brown wire of the pigtail should be hooked
up to L1, the blue wire to L2, and the green/yellow wire to the
ground GND.
www.stiebel-eltron-usa.com
7.3.2 Voltage
Model Voltage
Mini 2-1 110–120
V
Mini 2.5-1 110–120
V
Mini 3-1 110–120
V
Mini 3.5-1 110–120
V
Mini 4-2 220–240 , 208
V
Mini 6-2 220–240 , 208
V
1. All electrical work must comply with national and applicable state
and local electrical codes.
2. The Mini should be connected to a properly grounded dedicated
branch circuit of proper voltage rating. In installa tions with several
Mini units, each unit requires an independent circuit. Please refer to
the technical data table for the correct wire and circuit breaker size.
3. The open ends of the "pigtail" must be feed into an electrical
junction box. Then feed wires through strain relief clamp and tighten
clamp down on wire.
4. Reinstall plastic cover.
Mini Series Electric Tankless Water Heaters |
™
V
V
15