Direct Connection - Siemens ST-H Manual De Operación

Direct Connection

Connect the transducer directly to the Milltronics transceiver using the two conductor shielded
cable.
Note:
When connecting to an EnviroRanger ERS 500, a MultiRanger 100/200, or a
HydroRanger 200, the white, black, and shield wires are all connected separately. DO NOT
tie the white and shield wires together.
Coaxial Connection
Connect the transducer to the Siemens Milltronics transceiver via a junction box and RG–62 A/
U coaxial cable. This setup is effective for combined runs up to 365 m (1200 ft).
Note:
When connecting to an EnviroRanger ERS 500, MultiRanger 100/200, and
HydroRanger 200, do NOT use coaxial cable; see diagram below for proper procedure.
2-Wire Extension
(for EnviroRanger ERS 500, MultiRanger 100/200, and HydroRanger 200 only)
wht
Page EN-8
b
l
k
/
h
o
t
blk
blk
junction box
ST-H Transducer – OPERATION MANUAL
w
h
t
/
s
h
l
d
wht
drain/shield
Extend cable using RG-62 A/U coax.
drain/shield
Extend cable using 18 AWG shielded/twisted pair.
7ML19985QK81