Asus Crosshair II Guia De Instalacion página 11

2. Install the standoffs to the matched
screw holes on the metal plate.
4. Position the I/O side of the
motherboard toward the rear of the
chassis and place the motherboard
into the chassis.
• You may remove the metal slot covers for the expansion cards at the back
of the chassis before installig the motherboard. For some chassis models, it
might be difficult to remove the expansion slot cover after the installation.
• DO NOT over-tighten the screws. Doing so may damage the motherboard.
10
3. The I/O shield edge springs may
damage the I/O ports. Be cautious
when installing the I/O shield.
5. Insert and loosely tighten each
screw in a diagonal sequence first.
After all the screws have been
inserted, drive the screws until
they are finger-tight.
Chapter 1: Quick Start