Installing The Child Seat - Silver Cross Balance i-Size Manual De Instrucciones

Scan for the vehicle
compatibility list
10
Balance i-Size
Multi-Stage Car Seat
76-150cm
Notice: This child restraint system has been approved
under Regulation R129 to be used by children between 76 cm Motion
i-Size
to 150 cm in height. For use in, "i-Size compatible" vehicle
Scan for the vehicle
seating positions as indicated by vehicle manufacturers compatibility list 000012
in the vehicle users' manual. Please do not leave the child
360°
unattended inside the vehicle. Please read the instructions
carefully. Incorrect installation of the child restraint system
i-Size Motion Safe TM Easy Lock 5 Point safety 360° Rotating 5 Head rest 3 Recline Adjustable
compatible impact protection ISOFIX system harness seat unit positions positions support leg
could cause serious consequences for the child. In the case
Car safety made simple
of incorrect installation the manufacturer is in no way
responsible. This seat is classed as an i-Size Enhanced Child
Restraint System and i-Size booster seat. The ISOFIX meets size
Motion
classes ISO F2X and ISO B2.
i-Size
IMPORTANT – DO NOT USE BEFORE THE
CHILD'S AGE EXCEEDS 15 MONTHS 000012

1. INSTALLING THE CHILD SEAT

INSTALLATION FROM 76-105cm / <20.5kg
1.1 Slide the ISOFIX connector arms B (5) to
their maximum length by turning the ISOFIX
connector arms extension lever A (16).
Do this on both sides of the seat.
Extend the top tether and place (4) on top
of the seat.
1.2 Connect the ISOFIX connector arms
until you hear them click into place.
The ISOFIX connection indicator (17) will
turn from red to green. Push the seat as
far back as possible. Make sure that both
lSOFIX are in the same position once you
have pushed the seat back.
1.3 Connect the Top Tether in the anchor
point in the vehicle marked with the symbol:
The connector may be closed without being
secured in the ISOFIX anchor. Please make
sure that the connectors are correctly
fastened into the anchor points of the
vehicle by pulling the seat once it has
been installed.
To detach the seat follow the same steps
in reverse.
Move the button(15) to open the connector
and release the anchors.
INSTALLATION FROM 105-150cm
Follow the same steps as before. In this case
you should not connect the Top Tether.
There is also the option of installing the seat
only with the car seat belt when using the
105-150cm mode however where possible it
is recommended to use ISOFIX.
silvercrossbaby.com
ENG
FRA
SPA
ITA
DEU
SWE
FIN
RUS
ZH-S
ZH-T
ARA
11