604 533 Anl. Kranwagen m. F.
Function
The "Goliath" crane car is a working digital model,
equipped with a special decoder, three miniature
drive systems, and a mechanism derived from the
prototype, with correct block and pulley arrange-
ments. The functions for this railroad crane can be
selected on digital layouts with the 6021 Control
Unit using the function buttons on this unit:
f 2 : Raise or lower the boom
f 3 : Raise or lower the line with the main hook
f 4 : Rotate the crane cab to the right or the left
The direction of the work being done is determined
with the speed control knob, and the speed of
the work is controlled with a fine touch with this
same knob.
The outrigger support arms on the sides can be
unfolded and adjusted at the desired work location
for the necessary height on the support bases
included with the crane car. Just as with the proto-
type, heavier loads can be raised before reaching
the tipping point, if the boom is in a raised position
than if the latter is set in a lower position.
When the crane car is in its transport position,
it can be operated with the outrigger support arms
prototypically stored, and it will automatically
adjust to a straight position after passing through
curves (360 mm / 14-3/16'' radius or greater).
11.11.2005
11:00 Uhr
The outrigger support arms must be fully retracted
when doing this. Please make sure that you have
sufficient clearance on both sides of the track where
you will be running the crane car. We recommend
doing careful test runs.
This crane car is not designed for operation with
conventional transformers, in the DELTA system
and with the 6020 Central Unit; it is also not de-
signed for operation with locomotive controllers
of other makes (DC power, pulse width control,
multi-train controls of other makes).
Important:
The drive trains are protected against overloading
slip clutches. However, you should turn the crane
cab or the drums for the lines by hand very care-
fully and only if necessary; if at all possible, use the
digital controls. Please pay attention to the correct
position of the guides for the lines and use the
transport restraints when parking the crane car.
The drive train and the mechanism inside the crane
require no maintenance. All maintenance work can
be performed on the outside and is described below.
Please do not try to open the crane car up – without
special tools and knowledge this model will become
damaged. Please see your authorized Märklin
dealer for repairs or spare parts. Please also take
note of the warranty card included with this model.
Seite 7
7
