NORMAL MAINTENANCE
No lubrication is required for any moving parts, motor, bearings, or on sharpening surfaces.
Once a year or so as needed you should remove metal dust that will accumulate
inside the sharpener from repeated sharpenings.
Remove the small rectangular clean-out cover
(Figure 15) that covers an opening on the underside
of the sharpener. You will find metal particles adhered
to a magnet attached to the inside of that cover.
Simply rub off or brush off accumulated filings from
the magnet with a paper towel or tooth brush and
reinsert the cover in the opening. If larger amounts of
metal or other dust have been created you can shake
out any remaining dust through the bottom opening
onto a newspaper, paper towel, or other paper sheet
when the cover is removed. After cleaning, replace
the cover securely with its magnet in place.
The exterior of the Model 290 can be cleaned with
a damp soft cloth. Do not use detergents or abrasives.
SERVICE
In the event post-warranty service is needed, return your sharpener to the EdgeCraft factory
where the cost of repair can be estimated before the repair is undertaken. Outside the USA,
contact your retailer or national distributor.
Please include your return address, daytime telephone number and a brief description
of the problem or damage on a separate sheet inside the box. Retain a shipping receipt as
evidence of shipment and as your protection against loss in shipment.
Customer Service (800) 342-3255 or 610-268-0500
Assembled in the U.S.A.
This product may be covered by one or more EdgeCraft patents and/or patents pending as
marked on the product.
Chef'sChoice
, EdgeCraft
®
EdgeCraft Corporation, Avondale, PA.
Conforms to UL Std. 982
© EdgeCraft Corporation 2017
H17
EdgeCraft Corporation
825 Southwood Road, Avondale, PA 19311 U.S.A.
, Diamond Hone
®
Certified to CAN/CSA Std. E60335-1/4E
Figure 15. Removing cover under base to
clean out metal dust (see Normal
Maintenance section).
and Hybrid
are registered trademarks of
®
®
12
www.chefschoice.com
C2982S0