General Maintenance - Far Tools GGC 3300 Traduccion Del Manual De Instrucciones Originale

-
Operating the generator set
a)
When the generator has stabilised its speed (1 min), connect the male connector(s) into
the female connector of the AC generator. Depending on the model, check that the circuit
breaker is engaged. From this moment, you can use your electrical equipment
-
Shutting down the generator set
a)
Disconnect the connectors to allow the motor to run off-load for 1 or 2 min. Set the on/off
switch (13) to «OFF»: the generator shuts down
b)
Close the petrol cock
CHECKING THE OIL LEVEL
CHECK THE OIL LEVEL EACH TIME THE MOTOR IS STARTED AND EVERY 8 HOURS OF
OPERATION
OIL DRAINING
DRAIN THE MOTOR OIL AFTER THE FIRST 5 HOURS OF OPERATION AND SUBSEQUENTLY
EVERY 50 HOURS
-While the motor is hot, remove the drain plug (1) and allow all the oil to evacuate into a
container.
-After the oil has completely evacuated, put the drain plug (1) back in position.
-Unfasten and remove the filling dipstick cap.
-Replace and refasten the filling dipstick cap on its neck.
-Wipe any trace of oil with a clean cloth.
118025-4-Manual-E.indd 30
.(17)

GENERAL MAINTENANCE

© FAR GROUP EUROPE
EN
.
6/09/13 12:12:36