Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3) Loosen the Cradle Adjustment Knob, then orient the aera as desired.
4) Tighten the Cradle Adjustment Knob to hold the aera in place.
5) Connect power/data cables.
NOTE:
as lighting conditions change.
Attach the aera to the
aera Cradle
yoke mount:
Release Button
1) Fit the bottom of the
aera into the cradle.
aera
2) Tilt the aera back until it
snaps into place.
Remove the aera from
the yoke mount:
1) Press the Release
Button on the side of
the mount to release the
Cradle Adjustment Knob
aera.
2) Lift out the aera.
Yoke Mount Assembly
Connect the cable:
Make all applicable cable connections per the below drawing.
Cradle
3.5mm Headphone/Audio Jack
Mini-USB Connector
to XM Receiver
(XM version only)
2
1) Loosen and remove the Cradle Adjustment Knob, spacer, and rubber washer.
2) Rotate the clamp assembly 90
3) Secure the clamp assembly to the rest of the yoke mount using the Cradle
Adjustment Knob, spacer, and rubber washer. Adjust the clamp angle before
fully tightening the Cradle Adjustment Knob.
Clamp Assembly
Power Plug (3A Fuse)
o
so that the clamp opening faces away from you.
Rubber Washer
Cradle Adjusment Knob
Spacer
3
Tabla de contenido
