Optional Connections; External Battery Connection - Tripp-Lite SmartPro SM2200RMDVTAA El Manual Del Propietario

Optional Connections

These connections are optional. Your UPS will function
properly without these connections.
USB and RS-232 Serial
1
Communications
Use the included USB cable (see
(see ) to connect the communication port on your
1b
computer to the communication port of your UPS. Install
on your computer the Tripp Lite PowerAlert software
appropriate to your computer's operating system.
EPO Port Connection
2
This optional feature is only for those applications which
require connection to a facility's Emergency Power Off
(EPO) circuit. When the UPS is connected to this circuit,
it enables emergency shutdown of the UPS's inverter.
Using the cable provided, connect the EPO port of your
UPS (see ) to a user-supplied normally closed or
2a
normally open switch according to the circuit diagram (see
). The EPO port is not a phone line surge suppressor; do
2b
not connect a phone line to this port.

External Battery Connection

3
Your UPS comes with a robust internal battery
system; external batteries are needed only to extend
runtime. Adding external batteries will increase recharge
time as well as runtime.
The illustration (see
External Battery Connector
battery pack cable. Complete installation instructions for
your battery pack appear in the battery pack owner's
manual. Make sure that cables are fully inserted into their
connectors. Small sparks may result during battery
connection; this is normal.
Do not connect or disconnect battery packs when the UPS
is running on battery power.
200912137 93-2968.indb 6
) or DB9 serial cable
1a
) shows the location of your UPS's
3
, where you will insert the
A
1a
1b
2a
2b
A
3
6
4-5
2/19/2010 10:38:20 AM