Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

38
THERMEX TFM 160, TFM 180 & TFM 190

INSTALLATION

The hood is intended for installation in a wall-mounted cabinet, and is supplied with an internal motor. The kitchen hood can either vent exhaust out
into the open air or re-circulate the air.
INSTALLATION OF THE NONE-RETURN VALVE
Mount the none-return valve on the hood before installing the hood:
1
Place the spring on one of the flaps for the
none-return valve.
INSTALLING THE HOOD
The hood is installed in the cabinet using the following steps:
1
Measure and cut a hole in the base of the
cabinet.
4
x2
Pre drill the holes in the cabinet.
2
Mount the none-return valve in the flange on
the hood.
2
Push the hood up into the hole, and mark the
drill holes.
5
x4
Push the hood up into the cabinet and secure it
with the four screws.
M 513052268209022016
3
NOTE: Make sure that the spring is held in
place by the plastic pins.
3
Take the hood down from the cabinet.
6
Install the exhaust outlet on the hood.
NOTE: Ensure that the none-return valve can
open and close freely.
Tabla de contenido
loading

Este manual también es adecuado para:

Tfm 180Tfm 190

Tabla de contenido