Tabla de contenido
English
Other hot beverages
Steam dispensing
Put a cup with the beverage you wish to heat under the right
or left steam nozzle (6).
Completely immerse the steam nozzle in the beverage.
Gradually open up the steam ta (7) , allow the beverage to heat
to the desired temperature, stop the flow of steam by turning
knob (7) the other way (towards "0").
Dispensing hot water
Put the pot below of pipe (8) and open the tap (9).
7
6
Water level control of boiler (when provided)
The machine is fitted with a series of automatic level control
devices to keep the water in the boiler at a pre-set level.
Filling the boiler with water using the manual service tap
This function should be used only if the electronic level control
devices are not working correctly.
Press the filling lever (5), taking care not to exceed the MAX.
level on the boiler water level indicator (13).
9
9
8
8
Heating milk for frothy coffee (cappuccino)
Use a tall narrow jug and fill it up to about the half-way mark.
Then plunge the steam jet pipe (6) into the milk.
Gradually open up the steam tap (7) and heat the milk for a
few seconds.
When the required amount of froth has been made and the
temperature is sufficiently high, stop the flow of steam by
turning knob (7) the other way (towards "0").
When the steam jet pipe (6) is no longer required, clean it
thoroughly with a sponge and a clean cloth.
Note: At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows:
Turn the nozzle towards the cup tray and carefully
activate steam dispensing at least once.
7
7
6
6
13
31
English
9
7
8
6
5
Tabla de contenido
