Intended Use - Oase Aquarius Universal Premium Eco 3000 Instrucciones De Uso

Ocultar thumbs Ver también para Aquarius Universal Premium Eco 3000:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24

Intended use

Aquarius Universal Premium Eco 3000 / Eco 4000 / 4000 / 5000 / 6000 / 9000 / 12000, referred to as "unit", may only
be used as specified in the following:
 For pumping clear water used for indoor and outdoor fountain pumps, table fountain pumps and statues.
 For operation with clean water.
 Operate in accordance with instructions.
 Operation under observance of the permissible water quality. ( Water quality)
The following restrictions apply to the unit:
 Do not use in swimming ponds.
 Never use the unit to convey fluids other than water.
 Never run the unit without water.
 Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
 Do not connect to the domestic water supply.
Installation
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
 Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
 Isolate the device (disconnect from the power supply) before carrying out any work on it.
The unit can be set up either submerged (A) or dry (B).
General preparatory work: Bolt on the suction unit (3) and fit the pressure socket (2). Connect the desired hose for the
water feature to the pressure socket. Adapt stepped hose connectors to the water supply and return in accordance with
the hose diameter (C). Remove the pump foot, if necessary. For this purpose, press the pump foot to the rear, as illus-
trated (D)
Submerged installation (A)
Operation with the pre-filter fitted. Push the pre-filter over the suction unit and fasten the filter using the bayonet clo-
sure. Place the unit in the water at the desired position. Ensure that the unit is fully submerged. Maximum installation
depth:4 metres.
Dry installation (B)
Bolt the suction unit on and turn the priming opening to an optimum position for priming and connecting the suction
hose. Connect the suction hose to the suction unit. Always position the unit below the water line to prevent dry running
and the intake of air when switching on and operating the unit. Risk of damage!
Never connect the unit to a water line.
Install the unit so that it is not exposed to direct sun radiation (max. 40 ºC).
- EN -
11
Tabla de contenido
loading

Tabla de contenido