DeWalt D25604 Manual De Instrucciones página 7

SHOCKS Active Vibration Control® System
(Fig. A, F)
D25604, D25652, D25831, D25851
For best vibration control, hold the tool with one hand
on the main handle 4 and the other hand on the side
handle 3 . Apply just enough pressure so the damping
device on the main handle is approximately mid stroke. The
hammer only needs enough pressure to engage the active
vibration control. Applying too much pressure will not make
the tool drill or chip faster and active vibration control will
not engage.
Inserting and Removing Spline Drive
Accessories (Fig. C)
D25652, D25851

WARNING: Burn hazard. ALWAYS wear gloves when
changing bits. Accessible metal parts on the tool and
bits may get extremely hot during operation. Small
bits of broken material may damage bare hands.

WARNING: Do not attempt to tighten or loosen drill
bits (or any other accessory) by gripping the front part
of the chuck and turning the tool on. Damage to the
chuck and personal injury may occur.
1. Insert the bit shank into the tool holder
it will go. The groove on the chisel shank
be aligned with the symbol
inserted correctly, the locking sleeve
the end position and shows a closed lock symbol.
2. Pull on the bit to be sure that it is properly locked.
3. If the chisel groove is not aligned with the symbol, or
is not inserted to the complete depth the lock symbol
remains open.
4. To remove the bit, pull back the locking sleeve and pull
the bit out.
Fig. C
15
13 as far as
17 must
on the toolholder. If
15
moves back to
16
13
16
17
Inserting and Removing SDS Max
Accessories (Fig. D)
D25604, D25831
1. Pull back the locking sleeve
The bit shank must be clean.
2. Turn the bit slightly until the sleeve snaps back
into position.
3. Ensure the bit is properly engaged.
nOTE: The bit needs to move several centimeters in and
out of the tool holder
13
4. To remove the bit, pull back the locking sleeve and pull
the bit out.
Fig. D
13
E-Clutch® System (Fig. E)
D25604, D25652
In addition to the clutch, the D
system, E-Clutch®, offers increased user comfort through
an on-board, anti-rotation technology capable of detecting
if the user loses control of the hammer. When a jam is
detected, the torque and speed are stopped instantly. This
feature prevents self-rotation of the tool. The red indicator
LED 9 illuminates when the E-Clutch® System is engaged.
Fig. E
7
9
10
English
and insert the bit shank.
16
when properly engaged.
16
WALT an anti-rotation
e
5