Rinsing Cycle; Factory Settings - Gaggia SYNCRONY DGT SILVER SUP015ST Instrucciones De Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 78
ENGLISH
DESCALING SIGNAL
This function permits to reset the "DESCALING"
message after descaling the machine.
• In the programming mode, press "∧ ∧ ∧ ∧ ∧ " or "∨ ∨ ∨ ∨ ∨ "
to select the function:
SIGNAL. DESCAL.
and enable it by pressing "ENT".
The following message will appear:
SIGNAL. DESCAL.
NO
• Press "∧ ∧ ∧ ∧ ∧ " or "∨ ∨ ∨ ∨ ∨ " to select the function:
SIGNAL. DESCAL.
YES
• Press "ENT" again to reset the scale counter.
• Should this function be selected when the
message "DESCALING" is not shown on the
display, the following message will appear:
QUANTITY WATER
NOT REACHED
Press "ESC" to go back to the programming
mode.
Important: if you do not wish to reset
the counter, press "ESC".
Important: after routine descaling, it
is recommended to reset the counter.
This will prevent you from forgetting to
descale the appliance.
TIMER
The machine can be programmed to switch
automatically from the
SELECT PRODUCT
READY FOR USE
function to the
ENERGY
SAVING
mode after a certain amount of time has
elapsed. The timer may be set from 0 to 12
hours, with 15-minute intervals.
The timer starts counting from zero after every
dispensing operation.
If "0:00" is shown, it means that the timer is off.
• In the programming mode, press ∧ ∧ ∧ ∧ ∧ " or "∨ ∨ ∨ ∨ ∨ "
to select the function:
and enable it by pressing "ENT". The display
will show:
• Press "∧ ∧ ∧ ∧ ∧ " or "∨ ∨ ∨ ∨ ∨ " to select the desired time
and memorise the setting by pressing "ENT".
With this function, all the coffee brewing parts
undergo a rinse cycle with water.
hand to supervise the operation.
• To start the rinse cycle, press "∧ ∧ ∧ ∧ ∧ " or "∨ ∨ ∨ ∨ ∨ " to
select the function:
to enable the function press "ENT". Press
"ENT" again to start the rinse cycle.
• When the rinse cycle is completed, the
following message will appear.
At this point fill the water tank. The machine
will automatically switch to the normal
operating mode and the following message
will appear on the display:
.
This function allows you to restore the default
machine operating parameters set by the
• 38 •
TIMER
STANDBY
AFTER

RINSING CYCLE

During the rinse cycle it is
recommended that a person be on
RINSING CYCLE
FILL WATERTANK
SELECT PRODUCT
READY FOR USE

FACTORY SETTINGS

0:00
Tabla de contenido
loading

Este manual también es adecuado para:

Sysch014mengrcoSyncrony digital silver sup025ydr740610024

Tabla de contenido