Precor SPINNER CHRONO POWER Guía De Inicio página 5

To attach the seat assembly:
1. Slide the seat assembly onto the seat post (Figure 6).
2. Insert one bolt into the underside of the seat slider and fully tighten it to set the travel limit (Figure 7).
Note DO NOT forget to insert this bolt and set the travel limit.
3. Attach the seat slider end cap
Figure 6
To attach the handlebar assembly:
1. Slide the handlebar assembly onto the handlebar post (Figure 9) by loosening the fore/aft handlebar knob and pulling it up to align with the grooves
in the handlebar post.
2. Insert one bolt into the post and fully tighten it to set the travel limit (Figure 10).
Note DO NOT forget to insert this bolt and set the travel limit.
3. Attach the handlebar post end cap using two bolts
Figure 9
Attach the Pedals
Hold the pedals with the toe straps facing forward.
To attach the pedals:
1. Insert a pedal into its corresponding crank arm (Figure 12).
2. Use a rubber mallet to lightly tap the center of the pedal into the crank arm to seat it (Figure
12).
3. Secure the pedal using one bolt
key .
4. Repeat Steps 1-3 to attach the other pedal.
Level the bike
Important Place the equipment on a flat surface. Rotating the adjustable feet does not compensate for extremely uneven surfaces.
Make sure the bike is level before allowing anyone to use it.
To level the bike:
1. Try to rock the bike. If there is any movement, tip the bike to one side to locate the adjustable feet (see accompanying graphic).
2. Correct the height of each adjustable foot by turning it clockwise (+) to lower the bike, or counterclockwise (-) to raise the bike.
3. When you are finished leveling the bike, place it on the floor. Recheck for movement and readjust as necessary.
Bike assembly checklist
Important Your new Spinner Chrono bike comes with an innovative Kevlar® timing belt. This belt may require a break in period of 8 to 16 hours of normal use. During
this time, you may experience more noise and vibration than normal operation. After the break in period, your bike should operate smoothly. If you experience any issues
after the break in period, please contact Precor Customer Service.
Use this checklist to make sure your bike is assembled properly.
Check that all bolts are tightened to proper torque specification and no parts are missing.

Check that the handlebar and seat posts move freely and lock in different positions.

Check that the seat is level and does not rotate or tilt. Tighten and adjust as needed.

Test the seat for movement front to rear.

Brake tension is adjustable by turning the resistance knob in the front of the seat. Pressing down on the knob will apply the brake if you need to stop quickly.

Pedal the bike at a moderate pace and test the resistance knob for smooth resistance changes.

Press down on the knob to ensure the bike stops quickly.

Once testing is complete, tip the bike forward using the handlebars and roll it on a smooth surface to its final use location. Turn the adjustable feet to level the bike.
Spinner® Chrono™ Assembly Guide | P/N 304562-102 rev B, ENU
©2017 Precor Incorporated | November 2017
using three bolts (Figure 8) and fully tighten with the hex key
(Figure 11) and fully tighten with the hex key
(Figure 13) and torque to 33 ft-lb (45 N-m) with the hex
.
Figure 7
.
Figure 10
Figure 8
Figure 11
Figure 12
Figure 13
Figure 14