Caster Assembly - Uline DEWALT H-8931 Manual Del Usuario

1. Pull lid latches in outward motion, remove power
head and any accessories that may have been
shipped in tank.
2. Attach accessories following these instructions.
3. Before replacing power head, refer to these
instructions to ensure proper filters are installed for
the cleaning operation.
4. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in place.
Ensure all lid latches are clamped securely.
5. Insert air hose end into inlet of tank.
6. Attach extension wands to the accessory end of
hose. Apply slight pressure until fitting is tight.
7. Attach one of the cleaning accessories (depending
on cleaning requirements) to extension wands. Twist
slightly to tighten connection.
8. Plug cord into wall outlet. Vacuum is ready for use.
9. To reduce risk of injury from accidental starting,
always shut off vacuum and disconnect the power
plug from wall outlet before installing any part or
cleaning accessory.

CASTER ASSEMBLY

1. Invert tank.
2. Align casters with indented caster grooves in tank.
3. Firmly push casters down into position. Secure each
with one provided screw. (See Figure 1)
Figure 1
PAGE 4 OF 21
OPERATION
ACCESSORY BAG HOLDER BRACKET
ASSEMBLY
Place accessory bag holder into hole of bracket.
(See Figure 2)
WARNING: To reduce the risk of fire or explosion,
do not operate unit in areas with flammable
gases, vapors or explosive dust in the air.
Flammable gases or vapors include but
are not limited to: lighter fluid, solvent-type
cleaners, oil-based paints, gasoline, alcohol or
aerosol sprays. Explosive dusts include but are
not limited to: coal, magnesium, aluminum,
and grain or gun powder. Do not vacuum
explosive dust, flammable or combustible
liquids or hot ashes. Do not use this vacuum as
a sprayer for any flammable or combustible
liquid. To reduce the risk of health hazards from
vapors or dusts, do not vacuum toxic materials.
WARNING: The operation of any utility vacuum
can result in foreign objects being blown into
the eyes, which can result in severe eye injury.
Always wear safety goggles complying with
ANSI Z87.1 (or in Canada, CSA Z94.3) before
starting operation.
CAUTION: To reduce risk of hearing loss,
wear ear protectors when using vacuum for
extended hours or when using it in a noisy area.
Unit is ready for dry vacuuming. After plugging
the power cord into the wall receptacle, turn
unit "ON" by pushing switch position to the "ON"
position. (See Figure 3)
Figure 3
Figure 2
ON OFF
0421 IH-8931