Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5 - adjusting the handle height
To raise the handles press the buttons (a) on the inside of each upper hinge. The handles will
automatically spring to a higher position.
To lower the handles press the buttons again (b) then push the handles down (c). Release the
buttons but keep pressing down on the handles until they lock in place.
6 - using the harness
A five point harness is provided to restrain your child. To unfasten push the button on the buckle
(a) and pull the clips clear.
To fasten the harness push the shoulder strap clips onto the waist strap clips (b) then push the
waist strap clips into the buckle until they lock in place (c).
Sliding adjusters are fitted on the shoulder straps (d), waist straps (e) and crotch strap (f). The
harness should be carefully adjusted so that it fits your child comfortably.
WARNING: Always use the crotch strap in combination with the
waist belt.
7 - adjusting and removing the harness
There are three different positions for the shoulder straps. To change the shoulder strap height
remove the chest pads by releasing the fabric fastener along the length of the chest pad (a).
Unfasten the front buckle (b) then separate the shoulder strap clips and waist strap clips (See step 6).
Open seat retaining flap (c).
Flatten the retainer tab (d) and pull the shoulder strap away through shoulder strap slot (e) from
the rear of backrest.
From behind, push the shoulder straps back through the desired slots in the backrest (f).
Refit the chest pads.
Please ensure that after fitting there is one retainer tab on each side of the backrest for both
shoulder and waist straps (g).
To remove the harness for cleaning unfasten the shoulder straps from both front & rear buckles
and then push through the slots in the backrest (h).
Push the waist straps through the backrest (i).
Push the crotch strap clips through the slots under both side of the seat (j). Note: Pull the backrest
further forward to access and remove the parent facing mode crotch strap.
Refitting the harness is a reversal of this process. Please ensure that after fitting there is one
retainer tab on each side of the backrest for both shoulder and waist straps (g).
8 - preparing the pushchair for parent facing mode
The most reclined position in parent facing mode is recommended for new born babies until ready
to progress to more upright position. (e.g. this may be when they can sit up unaided.)
If fitted, pull the seat retaining flap away from behind the top of the backrest (a).
Pull the seat back forwards until it rest on top of the calf support (b).
Note: Before proceeding, unfasten the zip and check that the head pad is fitted (c) in the correct
position. The head pad should be on top of the support boards.
Fasten the seat retaining flap on the underside of the calf support (d).
Lift the lever (e) on the back of the backrest and lower it to form the foot section of parent
facing mode (f).
When use in parent facing mode, this section must only be used in its lowest position.
Tabla de contenido
