Tabla de contenido
Idiomas disponibles
Idiomas disponibles
To retract the sunvisor, push it down & back into the hood (d).
There is a flap on the rear of the hood. Lift the flap to view inside the pushchair (e). Lower the flap
to close.
There is a pocket on the rear of the hood. Lift the flap (f) to gain access to the pocket. Maximum
weigh in hood pocket 0.2kg.
21 - positioning the backrest
The backrest can be adjusted. To lower, simply lift the lever behind the backrest (a) and release the
lever at desired position. To raise the backrest is a reversal of this procedure.
22 - fitting the drinks holder
Push the drinks holder down on to its mounting bracket until it locks in place.
Lift the drinks holder off the bracket to remove.
NOTE: The cup holder must only be used when the seat is in forward facing mode.
23 - using the calf support - forward facing mode
Press the buttons on both sides of the calf support (a) and lift (b) or lower (c) the calf support to
the desired position. Release buttons (a) to lock the calf support in position.
24 - removing the basket
The basket is removable for easier cleaning. To remove your basket, undo the poppers on the four
straps, two at the back (a) on either side and two at the front behind the calf support hinges (b).
To re-fit your basket, simply reverse the above process. Maximum load 2kg of goods, evenly
distributed.
25 - fitting the raincover
The procedure for fitting the raincover is the same for parent facing and forward facing mode.
Fit the raincover over as shown.
The middle handle passes through hole in the centre of the raincover (a).
Fasten the fasteners, three on each side at the back of the raincover (b).
At the front wrap the webbing straps around the chassis legs and fasten the popper (c).
Opening the raincover to gain access to your child - Parent facing mode:
Release the three fasteners at the back of the raincover (b) and lift the rear flap up.
Opening the raincover to gain access to your child - Forward facing mode:
Open the zip fastener on each side of raincover (d) and lift the front of the cover up and forwards (e).
26 - fitting the raincover bag
NOTE: The raincover bag is designed to hold the raincover only when it is not in used.
Push the clip (a) onto the mounting bracket until it locks in place. (The same mounting bracket is
used for the drinks holder).
Wrap the fabric fasteners (b) around the pushchair leg tubing.
To open and close the raincover bag, press the button (c) on bag clip then, while holding the bag
strings, push or pull the clip backwards or forwards (d).
27 - removing the seat cover for cleaning - 1
Secure attachment of the seat cover is critical to the safety performance of your pushchair.
Removing and re-fitting involves a series of fasteners as per instruction below – please follow this
information carefully.
Tabla de contenido
