Using The Raincover - Cosatto SUPA NITTY GRITTY Manual De Instrucciones

Note: Your tablet computer must be no more than 250mm x 190mm x 10mm (9.5 inch x 7 inch
x 0.3 inch) in size and weigh no more than 700g (1.5lb).
Remove your tablet computer before folding back the hood or closing the pushchair.
WARNING:
•
section at the beginning of the document regarding the safe
use of the speaker and tablet computers.
14 - fitting the drinks holder
Push the drinks holder down on to its mounting bracket until it locks in place.
Lift the drinks holder off the bracket to remove.
NOTE: To avoid risk of injury from burning, do not place hot beverage in drinks holder.

15 - using the raincover

With the hood opened or in the extended position, place the split, shorter section of the
raincover over the hood so that it hangs at the rear of the pushchair (a).
At the front wrap the straps around the chassis and fasten the press studs (b).
At the back secure using the fastener tabs at the rear (c).
16 - removing the seat for cleaning
Secure attachment of the seat cover is critical to the safety performance of your
pushchair.
Removing and re-fitting involves a series of fasteners as per instruction below – please follow this
information carefully.
Tips:
• Having the pushchair semi-folded will release tension in the seat cover and make the fabric
sections easier to remove
• When passing the buckle through the plastic slots, keep the curve of the buckle in line with the
curve of the tubing and ease through the slot. If this is tight, use a blunt edge e.g. a coin or
broad screwdriver blade to help.
Unzip the top of the backrest and remove the three panels from inside (a).
Unfasten the fastener tabs at the rear of backrest holding the seat cover to backrest tubing (b).
Unclip the waist straps from the frame by unfastening, then feeding the edge of the webbing
through the opening of the metal clip (c).
Unclip the seat straps by folding the buckle flat and pushing it through the slot in the mounting
block (d). There are three buckles on each side of the pushchair. One at the top of the backrest
and two on the underside of the seat.
Unclip the seat support strap from under the seat by feeding the edge of the webbing through the
opening of the metal clip (e) and unwrapping the strap from the frame on each side (f).
Undo the strap under the footrest (g).
Slide the seat cover off the footrest legs (h). Slide the seat cover off the backrest arms (i).
Reverse these steps to refit.
17 - folding the pushchair
Note: Before folding ensure the backrest is in the most upright position. Always remove the
raincover, placing it in the basket and fold the hood completely back.
To fold your pushchair lift the handles (a) and at the same time press down on the secondary lock (b).
Keeping the secondary lock pressed down, push the handles forward until the pushchair is folded
in half. Continue until the pushchair is folded in half and the autocatch engages.
Note: Take care not to damage the stand mechanism when folding. Pressing down too hard on
See the "safe use of electronic goods"